We are Manufacturer, Supplier, Exporter of Saftey Light Curtains and our setup is situated in Pune, Maharashtra, India.
Features
☛ Offers Safety Standard Type 4 when used with Controller.
☞ Easy to install & can be mounted in any position. Vertical / Horizontal.
☛ Non-Critical alignment between Emitter & Receiver.
☞ Blanking / By-Passing individual channel is provided through software.
☞ System operation is unaffected by mains power fluctuations.
☞ Machine OFF if screen is too dirty or oily.
☞ Barrier operates on cyclic scanning photo-electric infra-red techniques.
☞ Various barrier heights are available for covering 90 mm to 1890 mm .
☞ Higher covering heights available upon request.
☞ Sensor connections are provided through plug in connectors.
☞ Use of solid state components & special construction technique ensures that barrier is not affected by normal vibrations & shocks.
☞ Self Checking Circuitry with two outputs continuously monitors failure of any of the beam in the system and stop the machine if failure is detected.
☞ LED Indications are provided for status indication of each channel.
☞ LED indications are also provided for each output.
☞ Choice for suitable Control Unit available as per different working conditions.
☞ Flexible fixing arrangements to suit individual requirement.
☞ Increases productivity while maintaining required safety.
Specification
| ☆ | Power Supply | : | 12 - 24 Volts DC |
| ☆ | Supply Protection | : | Reverse Polarity Protected |
| ☆ | Output | : | Duel Output : PNP or NPN / NO or NC |
| ☆ | Output Indications | : | Through LEDs |
| ☆ | Channel Indication | : | LED indication for each channel |
| ☆ | Response Time | : | On to Off : 10 - 15 m sec. Off to On : 50 - 100 m sec |
| ☆ | Restart | : | Automatic |
| ☆ | No of beams | : | 6, 8, 10, 16, 24, 32 nos. |
| ☆ | Beam By Pass | : | Provided in hand/body protection models |
| ☆ | Protected Heights | : | 90 - 1890 mm |
| ☆ | Pitch offered | : | 11 - 20 - 30 - 40 - 50 - 90 mm |
| ☆ | Adjustable Range | : | Up to 3 meters (Higher range up to 20 meters available) |
| ☆ | Electrical Connections | : | Plug in Connector for Emitter & Receiver |
| ☆ | Standard Cable length | : | 5 meters for emitter, 3 meters for receiver |
| ☆ | Operating Temperature | : | Up to 55 Degrees centigrade |
| ☆ | Fastening Modes | : | Slide Slot on the back with adjustable height |
| ☆ | Cross Section | : | 36 x 42 mm |
| ☆ | Applicable to | : | Directly work with PLCs / Controllers |
| ☆ | Suitable for | : | Machines with quick emergency stop |
| ☆ | Protections | : | Output short circuit protected. |
| ☆ | Vibration Resistance | : | Amplitude : 0.75 mm (p) Freq : 10 - 55 Hzs : Rate : 1 Octave / min |
| ☆ | Operating ambient Light | : | 500 Lux ( max.) when source is places opposite to receiver : > 3000 lux when source placed at an angle of 20 degrees |
Accessories
CE
All the models are also available with CE mark. Replace 2OP with CE for models with CE certification
| Type | Parallel Beam |
| No of Beams | 6 nos |
| Active Beams | 6 nos |
| Min.Range | 300 mm |
| Type | Cross Beam |
| No of Beams | 6 nos |
| Active Beams | 16 nos |
| Min.Range | 500 mm |
HAND Protection : Models with 2 Outputs
Supply : 12 - 24 Volts DC
Covered Range : 300 - 3000 mm, Duel PNP Output
LED Indication and By-Pass facility for each beam
FINGER Protection : Models with 2 Outputs
Supply : 12 - 24 Volts DC
Covered Range : 150 - 3000 mm, Duel PNP Output
LED Indication for final output
